水动力对沉积物-水界面氧通量产生机制的影响

选取三峡库区支流御临河为研究对象,测量了5个水动力条件（平均流速为0.00,0.03,0.07,0.12,0.20m/s）下沉积物-水界面（SWI）氧通量的变化及水动力条件对SWI氧通量产生机制的影响.结果表明,随着平均流速的升高,SWI氧通量增加,由0.00m/s时的1.197mmol/（m²·h）增加为0.20m/s时的43.981mmol/（m²·h）,溶解氧穿透深度增加,氧进入沉积物更深处并被微生物和还原性物质所利用,沉积物耗氧量上升;当平均流速较低时,沉积物耗氧量以生物耗氧量为主,在0.00m/s与0.03m/s时生物耗氧量为氧通量的85.3%与57.7%;当水体平均流速较高,化学耗氧量与其他耗氧量中的化学过程耗氧量在氧通量中的比重逐步提高.     

小型燃煤机组烟气重金属排放特征研究

100 MW以下燃煤机组呈单台容量小、总台数大的特点,是燃煤重金属污染的主要排放源之一.选择7台12 MW燃煤机组,采用美国环境保护局Method 29法现场检测燃煤机组烟气重金属排放浓度,分析烟气中Hg、Pb、Cr、As的排放特征;采集机组产生的飞灰和底灰,分析除尘技术对重金属的富集特性.结果表明:100 MW以下燃煤机组烟气中重金属经脱硝除尘脱硫装置协同控制后,ρ（Hg）为0.20~0.44 μg/m3,烟气Hg以气态形式存在,其占比为100.0%;ρ（Pb）为0.5~2.6 μg/m3,烟气Pb主要以气态形式存在,其占比为38.7%~92.1%;ρ（As）为0.6~3.0 μg/m3,烟气As主要以气态形式存在,其占比为67.8%~100.0%;ρ（Cr）为3.6~23.9 μg/m3,烟气Cr主要以颗粒态形式存在,其占比为65.8%~99.2%.飞灰富集Hg、Pb、Cr、As的能力大于底灰.重金属主要富集于飞灰中的细颗粒物中,采取除尘技术可有效协同控制烟气中的Hg、Pb、Cr、As;飞灰中重金属元素Hg、Pb相对富集系数均与煤中硫含量呈负相关,半干法脱硫+袋式除尘技术对飞灰富集Hg有促进作用.小型燃煤机组烟气重金属Hg、Pb、Cr、As的排放因子分别为0.002 2~0.005 1、5~17、42~160、7~24 mg/t.研究显示,100 MW以下燃煤机组与100 MW及以上燃煤机组烟气重金属Hg、Pb、Cr、As排放特征不同,100 MW以下燃煤机组烟气Hg排放浓度较小,二者烟气Pb、Cr、As排放浓度相近,选用湿式电除尘技术可进一步降低烟气Hg、Pb、Cr、As的排放浓度.      

电絮凝净化含聚污水影响因素研究

目的为保障油田正常安全生产,促进油田含聚污水的循环利用。方法采用电絮凝技术单因素研究方法开展净化含聚污水的静态实验研究,探讨外加电流密度、极板间距、初始pH及聚合物浓度等因素对净化效果的影响规律。结果当初始pH为7.0,电流密度为4.0 m A/m2,极板间距为1.0 cm,电解16 min时,综合处理效果最佳。此时,含油量与浊度去除率分别为98.85%,99.93%,处理每克油平均消耗为0.0494 g的Al,处理每立方米含聚污水的能耗为0.2895 k Wh。污水中的聚合物浓度越小,净化效果越好。结论中性处理,极板间距为1.0 cm,外加电流密度为4.0 m A/m2,通电16 min是最佳处理条件。     

The Variability of Estimates of Variance, and Its Effect on Power Analysis in Monitoring Design

Power analysis can be a valuable aid in the design of monitoringprograms. It requires an estimate of variance, which may come from a pilot study or an existing study in a similar habitat. For marine benthic infauna, natural variation in abundances canbe considerable, raising the question of reliability of varianceestimates. We used two existing monitoring programs to generatemultiple estimates of variance. These estimates were found to differ from nominated best estimates by 50% or more in 43% of cases, in turn leading to under or over-estimation of samplesize in the design of a notional monitoring program. The twostudies, from the same general area, using the same samplingmethods and spanning a similar time scale, gave estimatesvarying by more than an order of magnitude for 25% of taxa.We suggest that pilot studies for ecological monitoring programsof marine infauna should include at least two sampling times.     

Biological complexity confounds the separation of point- and non-point sources of human impact on the natural world

Identifying process from pattern is one of the most vexing tasks inenvironmental monitoring. Given information on the distribution of speciesin a pre-defined area, together with comprehensive data on how environmentalconditions in that area have altered through time, is it possible toidentify the factors controlling the species‘ layout? Here, the practicalsignificance of this quandary is demonstrated using a series ofenvironmentally-degraded coastal lagoons in New South Wales. The TuggerahLakes (33°17′S,151°30′E) have over the last 50 yearsexperienced significant changes in species‘ distributions. Seagrasses,macroalgae, phytoplankton, molluscs, prawns and the jellyfish Catostylus mosaicus have altered in spatial pattern. Two human activitieshave been blamed for these perturbations: (1) agricultural clearance ofnative vegetation from the catchment, with associated input of top-soil andnutrients; (2) the commissioning of a coal-fired power station in 1967, withmassive uptake and recirculation of lake water for cooling purposes. In thispaper, spatial changes in macrophyte distributions over the last 50 yearsare reviewed in an attempt to identify the true source(s) of perturbation.The model adopted assumes that the power station is a point source of impactwhile nutrient inputs from the catchment are a diffuse source of impact;changes in species distributions can hypothetically be related back to thesesources according to whether they are localised or widespread. However,after a comprehensive analysis of available macrophyte data derived frominterviews, aerial photography and line transect methodologyies theconclusion is reached that changes in biogeographical pattern around theTuggerah Lakes cannot be attributed to specific anthropogenic pressures atanything beyond the coarsest of levels. This is considered to be the normfor most coastal management situations where natural background variation(’noise‘) and the complexity of linkages between physical, chemical andbiological components confounds the identification of causal relationships.The practical implications of this conclusion are discussed in the contextof litigation and remedial management design. Emphasis is placed on theneed to adopt an adaptive approach to estuarine management, incorporatingexplicit recognition of the limitations of available data, and to developnew techniques for identifying cause-effect relationships.     

流动注射-氢化物发生-原子荧光光谱法测定土壤中铅

采用流动注射-氢化物发生-原子荧光光谱法测定土壤中的铅,工作曲线线性关系良好,检出限为0.25 mg/kg,相对标准偏差＜3.5%,加标回收率为93.0%～105%.该方法简便快速,测定结果准确可靠.     

中国能源的现状

研究中国能源的现状，其中主要包括能源储量和能源生产以煤为主；石油和天然气在能源构成中的比例低下；煤炭储量可观，但品质不高；能源生产增长迅速；能源短缺。尤其是清洁能源短缺，清洁能源危机将会长期存在。我国如此的能源现状已造成大气环境煤烟型严重污染。我国从石油输出国已变成石油进口国，我国半个多世纪以来实施的“能源自给政策”急需调整。采用洁净煤技术开发利用清洁能源，确保经济在持续迅速发展的同时，我国大气环境免遭污染，即经济发展和大气环境保护双赢。     

大理市生活垃圾焚烧处置初探

针对大理生活垃圾污染现状,提出采用高温焚烧方法处理大理市产生的城市生活垃圾的必要性,并用垃圾焚烧产生的热能发电.采取相应的措施防治燃烧过程中产生的污染物,可最终实现垃圾处理的减量化、无害化、资源化要求.     

电极旋转放电条件下O3合成效率的理论研究

根据低温等离子体理论和电磁场理论，在实验的基础上研究了电极旋转条件下低温等离子体的产生机制和臭氧的合成机制，分析了放电过程中二次放电重叠对臭氧合成的影响，建立了旋转放电与二次放电的理论模型，并根据这一理论模型导出电极旋转条件下的臭氧合成效率与二次放电重叠概率以及电极旋转速度间的理论关系．这一理论结果表明：二次放电重叠使得臭氧合成效率降低，而电极以适当地速度旋转则可以有效地避免二次放电的重叠，从而提高臭氧的合成效率．理论值和实验结果能够较好地吻合．     

重型柴油车污染物排放量计算方法比较分析

目的 计算大功率大吨位级重型柴油车的污染物排放量.方法 根据《公路隧道通风设计细则》和世界道路协会(PIARC)2012年技术报告,分别计算32 t重型柴油车的污染物排放量和稀释污染物所需的通风量,对比分析两种计算方法的差异.结果 对《公路隧道通风设计细则》中柴油车的车型系数和海拔高度系数提出建议.根据世界道路协会(PIARC)2012年技术报告,在0～2000 m低海拔地区,国产32 t柴油车的CO、NOx和烟尘排放量分别为88.6、166.0 m3/(h·veh)和84.2 m2/(h·veh),如果考虑NOx的空气污染,稀释单辆国产32 t柴油车排放污染物所需空气量约为33000 m3/h;如果不考虑NOx的空气污染,所需空气量约为28000 m3/h.结论 结合工程实际,建议大功率大吨位级重型柴油车的污染物排放量根据世界道路协会(PIARC)2012年技术报告进行计算.